User Manual

Command Reference Port Commands
12-66
character
The character to be used as the forward switch. To specify a control character,
use escaped hex (\xx). For example, Ctrl-B (ASCII character 0x02) would be
specified as \02.
None
Clears the current switch character.
Defaults None configured for serial connections; \06 (Ctrl-F) for virtual port logins
Examples
Local>> SET PORT 2 FORWARD SWITCH \02
See Also Forwards, page 12-9; Set/Define Ports Backward Switch, page 12-55; Set/
Define Ports Local Switch, page 12-67; Switching Between Sessions, page 8-5
12.6.27 Set/Define Ports Inactivity Logout
Enables automatic logout of the port if it has been “inactive” for a set period of time. Inactive is defined as
having no keyboard or network activity on the port. The port’s open connections (if any) will be closed
before logging out.
Note: The inactive period is configured using the Set/Define Server Inactivity
command.
This command is ignored for remote networking connections. See the Define Site Idle command.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also Define Site Idle, page 12-141; Set/Define Server Inactivity, page 12-120
SET
DEFINE



PORTS
PortList
ALL
INACTIVITY
LOGOUT
ENABLED
DISABLED


