User Manual

Command Reference Port Commands
12-64
See Also Define Ports Modem Control, page 12-97; Set/Define Ports Flow Control,
page 12-64; DTR (Data Terminal Ready), page 8-22
12.6.24 Define Ports Event Email Serialdata
Enables email notification for the serial buffering feature. This command automatically changes the
specified port’s access to Remote if not already set.
When email notification is enabled, an email is triggered when the specified serial port receives a burst of
20 or more characters in its serial log. The port will buffer the incoming data for up to 25 seconds or until
the log file reaches 1500 bytes before sending the email, which contains the current contents of the log file.
Any data that comes in after that 25 seconds will be discarded. Email can not be sent from the same port
more than once every 10 minutes.
Restrictions Requires privileged user status.
Port buffering must be enabled (Set/Define Ports Serial Log) for email
notification to work.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults set to None
See Also Set/Define Ports Serial Log, page 12-76; Define Email, page 12-49; ; Event
Port Logging, page 3-2; Email Alerts for Serial Events, page 3-2
12.6.25 Set/Define Ports Flow Control
Sets the type of flow control on the port.
Restrictions Requires privileged user status if you want to use this command on ports other
than your own. Secure users may not use this command.
DEFINE PORTS
PortList
ALL
EVENT EMAIL SERIALDATA
ENABLED
DISABLED



SET
DEFINE



PORTS
PortList
ALL
FLOW
CONTROL
NONE
CTSRTS
XONXOFF




