User Manual
Command Reference Port Commands
12-63
12.6.22 Set/Define Ports DSRLogout
When enabled, the port will be logged out when the port’s DSR signal is dropped. This usually only occurs
when the attached terminal device is powered off or disconnected; it is intended to keep users from
switching terminal lines to access other sessions. Any open connections will be closed before logging out.
Restrictions Requires privileged user access.
Errors Modem Control and DSRLogout are mutually exclusive.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
See Also DSR Logouts, page 8-10; Serial Signals, page 8-20
12.6.23 Set/Define Ports DTRWait
If enabled, the SCS will not assert the DTR signal on the serial port until a user logs into the port, connects
to the port via a service, or connects to the port via a Telnet connect. When the port is idle, DTR will not be
asserted.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
SET
DEFINE
PORTS
PortList
ALL
DSRLOGOUT
ENABLED
DISABLED
SET
DEFINE
PORTS
PortList
ALL
DTRWAIT
ENABLED
DISABLED