User Manual

Command Reference Port Commands
12-53
12.6.12 Set/Define Ports Autoconnect
If enabled, the port connects automatically to the preferred service upon login. To exit to character (Local>
) mode, the Break command can be used. To attach other services, the Connect command can be used.
Restrictions Requires privileged user status to use this command on ports other than your
own. Secure users may not use this command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Defaults Disabled
Examples
Local>> SET PORTS AUTOCONNECT ENABLED
See Also Set/Define Ports Preferred, page 12-71
12.6.13 Set/Define Ports Autostart
Determines whether the specified port will wait for a carriage return or pre-set character(s) before starting
a connection. Enabling Autostart causes the port to start connections automatically. Autostart can also be
configured to allow a user-defined sequence of one or two characters to initiate sessions.
SET
DEFINE



PORTS
PortList
ALL
AUTOCONNECT
ENABLED
DISABLED



SET
DEFINE



PORTS
PortList
ALL
AUTOSTART
ENABLED
DISABLED
CHARACTER
x
ANY
NONE





y
ANY
SAVE
1
2
NONE
















