User Manual

Command Reference Port Commands
12-51
Restrictions Requires privileged user status.
Errors If a port is active, its access cannot be set.
Autobaud must be disabled for Remote and Dynamic ports.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Dynamic
The ports can receive connection requests from local and remote users.
Local
The ports can only accept connection requests from local users (those
connected to the serial ports). No remote logins are permitted.
None
The specified ports are unusable.
Remote
The specified ports accept only network connection requests. No local logins
are permitted.
Defaults Dynamic
Examples
Local>> DEFINE PORTS ALL ACCESS LOCAL
See Also Setting Port Access, page 8-1; Limiting Port Access, page 11-22
12.6.10 Set/Define Ports Authenticate
When enabled, prompts incoming user for a username and password to be checked against the
authentication database(s) set up with the Set/Define Authentication commands.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
SET
DEFINE



PORTS
PortList
ALL
AUTHENTICATE
ENABLED
DISABLED


