User Manual

Command Reference IP/Network Commands
12-43
12.5.29 Show/Monitor/List Hosts
Displays either the currently available TCP/IP (Telnet/Rlogin) hosts (Show) or the ones that have been
Defined locally in the host table (List). Hosts will be shown with the method of discovery (rwho,
connection, host table, etc.) and will also be marked if they are the current nameserver and/or gateway.
Specifying a particular host name will show only that host’s information. Wildcards for the hostnames are
allowed. The All option is the default, and it displays all known TCP/IP hosts.
Restrictions You must be the privileged user to use the Monitor command.
Parameters hostname
Specifies a particular TCP/IP host.
All
Displays all the TCP/IP nodes that this server currently knows about. These
include hosts from the local host table, as well as hosts seen by Rwho
broadcasts and those resolved after a Connect/Telnet request.
Local
Displays local TCP/IP nodes.
Examples
Local> SHOW HOSTS ALL
See Also Set/Define Hosts, page 12-31; Adding Hosts to the Host Table, page 6-7
12.5.30 Show/Monitor/List IP
Displays the current operating characteristics of the targets. Use the List command to see the permanent
attributes that will take effect upon reboot/login.
SHOW
MONITOR
LIST





TELNET
HOSTS
hostname
ALL
LOCAL
SHOW
MONITOR
LIST





PROTOCOLS
IP
ALL
ROUTES
INTERFACES
ETHERNET
num
SiteName
CACHE
TRUSTED
HASHTABLE
SECURITY
ARP
NAT