User Manual

Command Reference IP/Network Commands
12-42
12.5.27 Set/Define IP Trusted
Configures a list of trusted routers. When Set/Define IP All/Ethernet Trusted is enabled, the SCS will
only listen to RIP updates from routers in this list.
Restrictions Requires privileged user status.
Parameters address
An IP address in standard numeric format (for example, 193.0.1.50).
RIP
When enabled, sets the specified IP address as a trusted routers. By default,
routers are not trusted.
See Also Set/Define IP All/Ethernet, page 12-32; Show/Monitor/List HostsTrusted,
page 12-43; Clear/Purge IP Trusted, page 12-18; Types of Routes, page 6-16
12.5.28 Show/Monitor/List 80211
Displays the current wireless networking settings. Entering the command without any parameters displays
basic 802.11 settings including Region, MAC address, and ESSID. Also displayed are any 802.11 errors,
which are discussed in Appendix B, Show 802.11 Errors.
Note: These commands are only valid on the SCS2.
Parameters Antenna
Displays the antenna diversity options (RX and TX) available on the currently
installed 802.11 card.
Power
Displays, in milliWatts, the transmit power settings supported by the currently
installed 802.11 card.
See Also Set/Define 80211, page 12-22; Show 802.11 Errors, page B-1
SET
DEFINE



PROTOCOLS
IP TRUSTED address
RIP
ENABLED
DISABLED



SHOW
MONITOR
LIST





80211
ANTENNA
POWER