User Manual

Command Reference IP/Network Commands
12-39
Restrictions Requires privileged user status.
Defaults Enabled
See Also IP Routing, page 6-15
12.5.24 Set/Define IP Security
Adds or changes entries in the IP security table.
Restrictions Requires privileged user status.
Parameters address
The IP address to be restricted. The address can be a full IP address, such as
192.0.180, to restrict one address; it can also be expressed as a partial address,
such as 192.0.1.255, to restrict whole subnetworks.
An address with a 255 in any segment means the restriction applies to all the
addresses in that range. Any address with a 0 in any segment implies Incoming
and Outgoing Disabled for all ports.
Both
Restricts both logins from the network to the server and Telnet sessions to the
network from the server.
Incoming
Restricts logins from the network into the server.
Outgoing
Restricts Telnet sessions from the network into the server.
Ports
A list of ports for which the restriction applies. To specify a port or list of ports,
use the PortList parameter. If PortList is not specified, all physical and virtual
ports apply. A port number of 0 i used to apply to the virtual (incoming login)
ports.
SET
DEFINE



PROTOCOLS
IP SECURITY
ADDRESS address
BOTH
INCOMING
OUTGOING





ENABLED
DISABLED



PORTS PortList
PRINTER
ENABLED
DISABLED















