User Manual

Getting Started System Passwords
2-7
When you click on a link in the left navigation column of the SCS web browser interface, you are prompted
for the privileged password. Once you enter the password, you can access all of the configuration pages.
If you are at the command line, become the privileged user by entering the following command.
Figure 2-6: Set Privileged Command
Note: The complete command syntax for Set Privileged is available on page 12-84.
To change the privileged password, use the Set/Define Server Privileged Password command (discussed
on page 12-124). Figure 2-7 displays an example of this command.
Figure 2-7: Changing the Privileged Password
Note: The privileged password is case-insensitive, so it does not need to be enclosed in
quotes.
2.3.2 Login Password
When you open the web browser interface for an SCS, you are prompted for the login password. To control
this setting, use the Server Login Password Required checkbox on the Server page.
Figure 2-8: Web Browser Authentication
When a serial port has the login password enabled, users must enter the correct password to access that
port’s Local> prompt. The default login password is access.
To change the login password, use the Set/Define Server Login Password command.
Figure 2-9: Defining the Login Password
Local> SET PRIVILEGED
Password> system (not echoed)
Local>>
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> DEFINE SERVER PRIVILEGED PASSWORD hippo
Local>> DEFINE SERVER LOGIN PASSWORD badger