User Manual

Command Reference IP/Network Commands
12-29
Parameters Reset
Resets the SCS to make all 802.11 changes take effect immediately. This
command should be entered anytime you make an 802.11 configuration
change. It also clears out any previous errors and starts over with the current
802.11 parameters.
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.11 Set/Define 80211 RTS
Changes the RTS threshold value.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters num
Enter a value between 0 and 3000.
Defaults 3000
Examples
Local>> DEFINE 80211 RTS 0
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
SET
DEFINE



80211 RTS num