User Manual

Command Reference IP/Network Commands
12-28
12.5.11.9 Set/Define 80211 Region
Sets the regulatory region under which you will operate the SCS. Users in the United States can leave this
at the default setting (FCC). Other users should set it to correspond with their region.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a region that will not work with your 802.11 card, an error bit will
be displayed when you enter the Show 80211 command.
Parameters Regions
IC: Canada
ETSI: Europe, most countries (verify with your local regulatory body)
SPAIN: Spain
FRANCE: France
MKK: Japan
Defaults FCC
Examples
Local>> DEFINE 80211 REGION FRANCE
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.10 Set 80211 Reset
Resets the SCS so any configuration changes will take effect immediately.
Restrictions Requires privileged user status.
Only applies to the SCS200.
SET
DEFINE



80211 REGION
FCC
IC
ETSI
SPAIN
FRANCE
MKK











SET 80211 RESET