User Manual

Command Reference IP/Network Commands
12-27
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters AdHoc
Specifies that the SCS is communicating with other wireless devices in a peer-
to-peer capacity.
Infrastructure
Specifies that the SCS is communicating with an Access Point (AP).
Defaults Infrastructure
Examples
Local>> DEFINE 80211 NETWORKMODE ADHOC
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.8 Set/Define 80211 Power
Controls the card’s transmit power settings. The numeric power setting specified must exactly match a value
supported by the card.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters Default
Sets the card to its default transmit power setting.
num
Enter a specific milliWatt power setting.
Examples
Local>> DEFINE 80211 POWER DEFAULT
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
SET
DEFINE



80211 POWER
DEFAULT
num


