User Manual

Command Reference IP/Network Commands
12-26
12.5.11.6 Set/Define 80211 MAC Address
Configures which of the two available MAC addresses the SCS will use on the network—its own or that of
the attached 802.11 wireless networking PC card. The SCS MAC address, which is the same as its hardware
address, is printed on bottom label of the SCS.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters Card
Instructs the SCS to use the MAC address of the wireless PC card that is
inserted into one of its PC card slots.
SCS
Instructs the SCS to use its own internal MAC address.
Defaults SCS
Examples
Local>> DEFINE 80211 MACADDRESS CARD
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.7 Set/Define 80211 Network Mode
Denotes whether the SCS operates in a peer-to-peer (AdHoc) or managed (Infrastructure) network
environment.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
SET
DEFINE



80211 MACADDRESS
CARD
SCS



SET
DEFINE



80211 NETWORKMODE
ADHOC
INFRASTRUCTURE


