User Manual

Command Reference IP/Network Commands
12-25
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters name
Enter a string of up to 32 characters. If the string contains lowercase letters or
non-alphanumerics, it may need to be enclosed in double-quotes to be
processed properly.
None
If no ESSID string is set, the SCS will communicate with whichever Access
Point (AP) gives the strongest signal, regardless of ESS association. Setting the
ESSID to none allows the SCS to associate with any AP within range.
Defaults ESSID=None
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.5 Set/Define 80211 Fragmentation
Changes the fragmentation threshold.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters num
Enter an integer between 256 and 2346 to change the fragmentation threshold.
Defaults 2346
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
SET
DEFINE



80211
FRAGMENTATION num