User Manual

Command Reference IP/Network Commands
12-22
EC
Erase Character
EL
Erase Line
GA
Go Ahead
IP
Interrupt Process
NOP
No Operation
SYNCH
Synchronize
12.5.11 Set/Define 80211
After you enter an 80211 configuration command, you must reboot the unit for the changes to take effect.
You can also enter the Set 80211 Reset command for all configuration commands except the Set/Define
802.11 Enabled/Disabled command, which requires a reboot.
Note: These commands are only valid on the SCS200.
12.5.11.1 Set/Define 80211 Enabled
When 802.11 is enabled, the SCS checks for a compatible 802.11 wireless Ethernet PC card at startup and,
if one is present, uses the card instead of a wired Ethernet port. If no valid PC card is detected at startup, the
SCS uses the 10/100BASE-T network connection.
When 802.11 is disabled, the SCS will ignore an installed 802.11 card and will only look for a compatible
wired Ethernet connection.
You must reboot the SCS before those changes will take place.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Parameters Enabled
Prompts the SCS to check for a compatible 802.11 wireless Ethernet
networking PC card at startup. If one is present, wireless networking will be
used instead of the wired Ethernet connection. You must reboot the SCS after
entering this command.
SET
DEFINE



80211
ENABLED
DISABLED


