User Manual

Command Reference Site Commands
12-148
12.10.13 Define Site Time
Configures the time ranges during which outgoing connections are allowed from this site, and during which
bandwidth can be adjusted for this site.
Restrictions Requires privileged user status.
Parameters SiteName
Enter a site name of up to 12 characters.
Add
When the Default setting is Enabled (see below), specifies when connections
are not allowed. When the Default setting is Disabled, specifies when
connections are allowed.
day
Specify the days during which Adding will start and stop. Must be followed by
both starttime and endtime parameters. If a second day is not specified, it is
understood that the start time and end time occur on the same day.
starttime, endtime
Specify the time when Add will go into effect, and the time when Add will end,
on the specified day. Times are specified in hh:mm format and are ordered with
respect to their time settings rather than the order in which they were entered.
Specified times are combined if appropriate.
Note: Show/Monitor/List Sites SiteName Time displays the specified time ranges and
their order.
Default
Set the default access parameter for the site.
If the default is enabled, connections are allowed except during the times
specified. If the default is disabled, connections are restricted except during the
times specified.
DEFINE SITE SiteName TIME
ADD day starttime
day
endtime
DEFAULT
ENABLED
DISABLED



CLEAR
number
ALL



FORCEDIAL
time
NONE
SESSION limit
FAILURE seconds
SUCCESS seconds




















