User Manual

Command Reference Server Commands
12-131
See Also Clear/Purge Menu, page 12-115; Set/Define Menu, page 12-116; Enabling
Menu Mode, page 8-12; Configuring Menu Mode, page 3-3
12.9.29 Show/Monitor/List Server
This command is used to display the global attributes or counters for the server itself.
Restrictions You must be the privileged user to use the Monitor command. The List Server
command can only be used with the Bootparams parameter.
Parameters Bootparams
Displays parameters related to rebooting the unit and reloading the software
file.
Clock
Displays the local time and date and the UTC (GMT) time and date.
Counters
Counters can be reset to zero with the Zero Counters All command. Displays
the accumulated error counters for the Ethernet and TCP/IP protocols. The
four-digit bit position numbers represent one of the network error reasons
listed below:
Table 12-5: Server Failure Reasons
Bit Send Failure Reason Receive Failure Reason
0 Unused, should be 0 Unused, should be 0
1 Unused, should be 0 Packet received with CRC error
2 At least one collision has occurred
while transmitting
Received packet did not end on byte
boundary
3 Transmit aborted due to excessive
(more than 16) network collisions
FIFO overrun: Could not write
received data before new data
arrived
4 Carrier sense was lost during
transmission
Receive packet could not be
accommodated due to lack of
receive buffers
SHOW
MONITOR
LIST





SERVER
BOOTPARAMS
CLOCK
COUNTERS
TIMEZONE