User Manual

Command Reference Port Commands
12-91
Restrictions Non-privileged users may only test their own port.
Virtual and multisession-enabled ports can only be tested by the user on that
port.
Parameters PortNum
Specifies a particular SCS port.
PostScript
Sends a Postscript test page to the port instead of ASCII data.
Count
Specifies the number of test lines to be send, or if in postscript mode, the
number of pages to print. Any character will terminate the test. Must be used
in conjunction with the lines parameter.
lines
The number of lines to be sent to the port. There is no line limit.
Width
The number of characters per line in the test pattern. Must be used in
conjunction with the characters parameter.
characters
Enter an integer between 1 and 132, inclusive.
DTR
Lowers and then raise the DTR signal on the serial port. If a delay is not
specified, DTR will lower for approximately one second and then raise.
Delay
Lowers DTR will for the specified delay length, then raises DTR.
num
Enter a delay time from 50 to 3,000 (milliseconds).
Examples
Local> TEST PORT
Local> TEST PORT 4 WIDTH 45 COUNT 5
12.6.60 Unlock Port
Unlocks a locked port, which may be necessary if the user has locked the port and forgotten the password.
The command does nothing if the port is already unlocked.
Restrictions Requires privileged user status.
Parameters PortNum
The number of the locked SCS port.
Examples
Local>> UNLOCK PORT 6
See Also Lock, page 12-46; Locking a Port, page 8-9; Locking a Port, page 11-20
UNLOCK PORT PortNum