User Manual

Command Reference IP/Network Commands
12-23
Disabled
Prompts the SCS to only look for a compatible 10/100BASE-T wired Ethernet
connection at startup. You must reboot the SCS after entering this command.
Defaults Enabled
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
12.5.11.2 Set/Define 80211 Antenna
Controls the antenna(s), if any, on the installed wireless card. Not all antennas can be used for both receive
and transmit, so be sure to read your card documentation completely. The default settings should work in
most applications.
Any configuration changes you make with the above commands will not take place until you reboot the SCS
or issue the Set 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the SCS200.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters RX
Specifies the antennas used to receive
TX
Specifies the antennas used to transmit.
list
Enter an integer or group of integers separated by commas (e.g. 1,2,3) to
specify the affected antenna(s). Antennas are numbered consecutively starting
with antenna number one. See the documentation that came with your card for
antenna numbering information.
Default
Sets the antennas to their default transmit and receive values.
Examples
Local>> DEFINE 80211 ANTENNA DEFAULT
Local>> SET 80211 RESET
See Also Show 80211, page 12-42; 802.11 Configuration, page 2-10
SET
DEFINE



80211
ANTENNA
RX
TX
list
DEFAULT


