User's Manual
Table Of Contents
- PremierWave XC HSPA+ User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Installation of PremierWave XC HSPA+
- 4: Using DeviceInstaller
- 5: Configuration Using Web Manager
- 6: Network Settings
- Network 1 (eth0) Interface Settings
- Network 1 (Link) Settings
- Network 1 (Failover)
- Network 2 (Cellular) Settings
- Network 2 (Link) Settings
- Gateway
- 7: Cellular
- 8: Action Settings
- 9: Line and Tunnel Settings
- Line Settings
- Tunnel Settings
- Serial Settings
- To Configure Tunnel Serial Settings
- Packing Mode
- To Configure Tunnel Packing Mode Settings
- Accept Mode
- To Configure Tunnel Accept Mode Settings
- Connect Mode
- To Configure Tunnel Connect Mode Settings
- Disconnect Mode
- To Configure Tunnel Disconnect Mode Settings
- Modem Emulation
- To Configure Tunnel Modem Emulation Settings
- Relay Output
- 10: Terminal and Host Settings
- 11: Services Settings
- 12: Security Settings
- 13: Maintenance and Diagnostics Settings
- Filesystem Settings
- Protocol Stack Settings
- SMTP Settings
- Diagnostics
- Threads
- Clock
- System Settings
- Discovery and Query Port
- 14: Advanced Settings
- 15: Security in Detail
- 16: Updating Firmware
- 17: Branding the PremierWave XC HSPA+
- Appendix A: Technical Specifications
- Appendix B: Compliance
- Appendix C: Technical Support
- Appendix D: Binary to Hexadecimal Conversions
- Appendix E: USB-CDC-ACM Device Driver File for Windows Hosts
PremierWave XC HSPA+ User Guide 8
17: Branding the PremierWave XC HSPA+ 96
Web Manager Customization ________________________________________________96
Short and Long Name Customization __________________________________________97
To Customize Short or Long Names _______________________________________97
Appendix A: Technical Specifications 98
Network _________________________________________________________________98
Cellular ______________________________________________________________98
Ethernet _____________________________________________________________98
Serial Interface ___________________________________________________________98
Serial Connector __________________________________________________________98
USB Interface ____________________________________________________________98
USB Connector ___________________________________________________________99
I/O Interface _____________________________________________________________99
Input ________________________________________________________________99
Output _______________________________________________________________99
I/O Connectors ___________________________________________________________99
LED Indicators ____________________________________________________________99
Security _________________________________________________________________99
Management ____________________________________________________________100
Software _______________________________________________________________100
Power _________________________________________________________________100
Environmental ___________________________________________________________100
Agency Approvals / Compliance _____________________________________________100
Dimensions _____________________________________________________________101
Warranty _______________________________________________________________101
Appendix B: Compliance 102
Appendix C: Technical Support 105
Appendix D: Binary to Hexadecimal Conversions 106
Converting Binary to Hexadecimal ___________________________________________106
Conversion Table _____________________________________________________106
Scientific Calculator ___________________________________________________106
Appendix E: USB-CDC-ACM Device Driver File
for Windows Hosts 108
PRELIMINARY DRAFT
PRELIMINARY DRAFT










