User Guide

Using the CLI
 To enter the FTP command level: enable -> config -> ftp
Using XML
 Include in your file: <configgroup name=”ftp server”>
Syslog Settings
The Syslog information shows the current configuration and statistics of the syslog. Here you can
configure the syslog host and the severity of the events to log.
Note: The system log is always saved to local storage, but it is not retained through
reboots unless diagnostics logging to the filesystem is enabled. Saving the system log to
a server that supports remote logging services (see RFC 3164) allows the administrator
to save the complete system log history. The default port is 514.
Table 9-4 Syslog Settings
Syslog
Settings
Description
State Enable or disable the syslog.
Host Enter the IP address of the remote server to which system logs are sent for storage.
Remote Port Enter the number of the port on the remote server that supports logging services. The
default is 514.
Severity Log
Level
Specify the minimum level of system message the PremierWave XC should log. This
setting applies to all syslog facilities. The drop-down list in the Web Manager is in
descending order of severity (e.g., Emergency is more severe than Alert.)
To View or Configure Syslog Settings:
Using Web Manager
 To configure the Syslog, click Syslog in the menu bar.
Using the CLI
 To enter the Syslog command level: enable -> config -> syslog
Using XML
 Include in your file: <configgroup name=”syslog”>
PremierWave XC User Guide 62