User Guide

Echo Pluses Set whether the pluses will be echoed back during a “pause +++ pause”
escape sequence on the Serial Line. Choices are:
 Enabled
 Disabled (default)
Echo Commands Set whether characters read on the Serial Line will be echoed, while the Line
is in Modem Command Mode. Choices are:
 Enabled
 Disabled (default)
Verbose Response Set whether Modem Response Codes are sent out on the Serial Line.
Choices are:
 Enabled
 Disabled (default)
Response Type Select a representation for the Modem Response Codes sent out on the Serial
Line. Choices are:
 Text (ATV1) (default)
 Numeric (ATV0)
Error Unknown
Commands
Set whether the Error Unknown Commands is enabled (ATU0) and ERROR is
returned on the Serial Line for unrecognized AT commands. OTherwise
(ATU1) OK is returned for unrecognized AT commands. Choices are:
 Enabled
 Disabled (default)
Incoming Connection Set how and if requests are answered after an incoming RING (ATS0=2).
Choices are:
 Disabled (default)
 Automatic
 Manual
Connect String Enter the customized Connect String sent to the Serial Line with the Connect
Modem Response Code.
Display Remote IP Set whether the Display Remote IP is enabled so that the incoming RING sent
on the Serial Line is followed by the IP address of the caller. Choices are:
 Enabled
 Disabled (default)
To Configure Tunnel Modem Emulation Settings
Using Web Manager
 To configure the Modem Emulation for a specific tunnel, click Tunnel in the menu bar and
select Tunnel 1 -> Modem Emulation.
Using the CLI
 To enter the Tunnel 1 Modem command level: enable -> tunnel 1 -> modem
PremierWave XC User Guide 55