User Guide

Block Serial Set whether Block Serial is enabled for debugging purposes. Choices are:
 Enabled = If Enabled, incoming characters from the Serial Line will not be
forwarded to the network. Instead, they will be buffered and will eventually
flow off the Serial Line if hardware or software flow control is configured.
 Disabled = this is the default setting; incoming characters from the Serial
Line are sent on into the network. Any buffered characters are sent first.
 Any Character = a connection is attempted when any character is read on
the serial line.
 Start Character = a connection is attempted when the start character for
the selected tunnel is read on the serial line.
 Modem Control Asserted = a connection is attempted as long as the
Modem Control pin (DSR) is asserted, until a connection is made.
 Modem Emulation = a connection is attempted when triggered by modem
emulation AT commands.
Block Network Set whether Block Network is enabled for debugging purposes. Choices are:
 Enabled = If Enabled, incoming characters from the network will not be
forwarded to the Serial Line. Instead, they will be buffered and will
eventually flow off the network side.
 Disabled = this is the default setting; incoming characters from the
network are sent on into the Serial Line. Any buffered characters are sent
first.
Email on Connect Select an email profile number to which an email notification will be sent
upon the establishment of an accept mode tunnel.
Email on Disconnect Select an email profile number to which an email notification will be sent
upon the disconnection of an accept mode tunnel.
To Configure Tunnel Connect Mode Settings
Using Web Manager
 To configure the Connect Mode for a specific tunnel, click Tunnel in the menu and select
Tunnel 1 -> Connect Mode.
Using the CLI
 To enter the Tunnel 1 Connect Mode command level: enable -> tunnel 1 ->
connect
Using XML
 Include in your file: <configgroup name="tunnel connect" instance="1">
Disconnect Mode
Specifies the optional conditions for disconnecting any Accept Mode or Connect Mode connection
that may be established. If any of these conditions are selected but do not occur and the network
disconnects to the device, a Connect Mode connection will attempt to reconnect. However, if
none of these conditions are selected, a closure from the network is taken as a disconnect.
PremierWave XC User Guide 53