User Guide

Table 7-4 Tunnel Packing Mode Settings
Tunnel Packing Mode
Settings
Description
Mode Configure the Tunnel Packing Mode. Choices are:
 Disable = Data not packed.
 Timeout = data sent after timeout occurs.
 Send Character = data sent when the Send Character is read on the Serial
Line.
Threshold Sets the threshold (byte count). If the received serial data reaches this
threshold, then the data will be sent on the network. Valid range is 100 to
1450 bytes. Default is 512.
Timeout Sets the timeout value, in milliseconds, after the first character is received on
the serial Line, before data is sent on the network. Valid range is 1 to 30000
milliseconds. Default is 1000.
Send Character Enter Control Characters in any of the following forms:
 <control>J
 0xA (hexadecimal)
 \10 (decimal).
If used, the Send Character is a single printable character or a control
character that, when read on the Serial Line, forces the queued data to be sent
on the network immediately.
Trailing Character Enter Control Characters in any of the following forms:
 <control>J
 0xA (hexadecimal)
 \10 (decimal).
If used, the Send Character is a single printable character or a control
character that is injected into the outgoing data stream right after the Send
Character. Disable the Trailing Character by blanking the field (setting it to
<None>).
To Configure Tunnel Packing Mode Settings
Using Web Manager
 To configure the Packing Mode for a specific tunnel, click Tunnel in the menu bar and select
Tunnel 1 -> Packing Mode.
Using the CLI
 To enter the Tunnel 1 Packing command level: enable -> tunnel 1 -> packing
Using XML
 Include in your file: <configgroup name="tunnel packing" instance="1">
Accept Mode
PremierWave XC User Guide 49