User Guide

To Configure Line Settings
Note: The following section describes the steps to view and configure Line 1 settings;
these steps apply to other line instances of the device.
Using Web Manager
 To configure a specific line, click Line in the menu bar and select Line 1 -> Configuration
(
Table 7-1).
 To configure a specific line in Command Mode, click Line in the menu bar and select Line 1 -
> Command Mode (
Table 7-2).
Using the CLI
 To enter Line 1 command level: enable -> line 1
Using XML
 Include in your file: <configgroup name="line" instance="1">
 Include in your file: <configgroup name="serial command mode" instance="1">
To View Line Statistics
Using Web Manager
 To view statistics for a specific line, click Line in the menu bar and select Line 1 ->
Statistics.
Using the CLI
 To view Line statistics: enable -> line 1, show statistics
Using XML
 Include in your file: <statusgroup name=”line” instance=”1”>
Tunnel Settings
Tunneling allows serial devices to communicate over a network, without “being aware” of the
devices which establish the network connection between them. Tunneling parameters are
configured using the Tunnel menu and submenus. The Tunnel settings allow you to configure
how the Serial-Network tunneling operates. Tunneling is available on all serial Lines. The
connections on one serial Line are separate from those on another serial port.
Note:
The following section describes the steps to view and configure Tunnel 1 settings;
these steps apply to other tunnel instances of the device.
Serial Settings
PremierWave XC User Guide 47