User Guide

Reset Button
You can reset the PremierWave XC to factory defaults, including clearing the network settings.
The IP address, gateway, and netmask are set to 00s. To reset the unit to factory defaults,
perform the following steps.
1. Place the end of a paper clip or similar object into the reset opening and press and hold
down micro switch during a power cycle for a minimum of 10-15 seconds.
2. Remove the paper clip to release the button. The unit will continue the boot process
restoring it back to the original factory default settings.
Top Panel
Figure 3-6 shows the top panel view of the PremierWave XC. Table 3-7 list and describes the
LEDs.
PremierWave XC User Guide 20