User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
9: Maintenance and Diagnostics Settings
PremierWave EN User Guide 48
System Configuration
The PremierWave EN allows for rebooting the device, restoring factory defaults, and
uploading new firmware.
Table 9-19 System Settings
System Settings
Description
Reboot Device
Run the reload command.
Restore Factory Defaults
Run the reload factory defaults command. All configuration settings
will be lost. The PremierWave EN automatically reboots upon setting
back to the defaults.
Upload New Firmware FTP to the PremierWave. Write the new firmware file to firmware.rom
on the PremierWave. The device automatically reboots upon the
installation of new firmware. See Chapter 13: Updating Firmware
Table 9-20 Using the CLI to Reboot or Restore Factory Defaults
Command level
enable>
Commands
reload
reload factory defaults