User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
9: Maintenance and Diagnostics Settings
PremierWave EN User Guide 47
Table 9-14 Using the CLI to Perform the Trace Route Command
Command level
enable
Command
trace route <host>
DNS Lookup
Here you can specify a DNS Hostname for a forward lookup or an IP address for a reverse
lookup.
Note: A DNS server must be configured for DNS Lookup to work.
Table 9-15 Using Forward or Reverse DNS Lookup
Diagnostics: DNS
Lookup Page Settings
Description
Host
Perform one of the following:
For reverse lookup to locate the hostname for that IP address, enter
an IP address.
For forward lookup to locate the corresponding IP address, enter a
hostname.
Table 9-16 Using the CLI to Perform a DNS Lookup
Command level:
enable>dns
Command
lookup <host_or_ip>
Memory
This read-only page shows the total, used, and available memory (in kilobytes).
Table 9-17 Using the CLI to View Memory Statistics
Command level
enable>device
Command
show memory
Processes
The PremierWave EN Processes command shows all the processes currently running on the
system. It shows the Process ID (PID), Parent Process ID (PPID), user, CPU percentage,
percentage of total CPU cycles, and process command line information.
Table 9-18 Using the CLI to Display the Running Processes
Command level:
enable>
Command
show processes