User Manual

9: Maintenance and Diagnostics Settings
PremierWave EN User Guide 45
File Transfer Commands
Files can be transferred to and from the PremierWave via the TFTP protocol. This can be
useful for saving and restoring XML configuration files.
Table 9-5 File Transfer Commands
File Transfer Settings
Description
TFTP
Action
Select the action that is to be performed via TFTP:
Get = a “get” command will be executed to store a file locally.
Put = a “put” command will be executed to send a file to a remote
location.
Local File
Enter the name of the local file on which the specified “get” or “put”
action is to be performed.
Remote File
Enter the name of the file at the remote location that is to be stored
locally (“get’) or externally (“put”).
Host
Enter the IP address or name of the host involved in this operation.
Port
Enter the number of the port involved in TFTP operations.
Table 9-6 Using the CLI to Transfer Files
Command level
enable>filesystem
Commands
ftp get <source file> <destination file> <host> (port)
tftp put <source file> <destination file> <host> (port)
Query Port
The query port (UDP port 0x77FE) is used for the automatic discovery of the device by the
DeviceInstaller utility. Only 0x77FE discover messages from DeviceInstaller are supported.
For more information on DeviceInstaller, see Using DeviceInstaller
on page 16.
Table 9-7 Query Port Settings
Query Port Settings
Description
state Enables or disables listening and responding to query port
messages.
Table 9-8 Using the CLI to Configure Query Port Settings
Command level
enable>configure>query port
Commands
state enable
state disable
show
Table 9-9 Using XML to Configure Query Port Settings
Configuration group name
query port
Configuration item name
State