User Manual

PremierWave EN User Guide 37
6: Configurable Pin Manager
The Configurable Pin Manager is responsible for assignment and control of the configurable
pins (CPs) available on the PremierWave EN. There are nine configurable pins on the
PremierWave EN.
You can configure the CPs by making them part of a group. A CP Group may consist of one
or more CPs This increases flexibility when incorporating the PremierWave EN into another
system.
CPM: Configurable Pins
Each CP is associated with an external hardware pin. CPs can trigger an outside event, like
sending an email message or starting Command Mode on a serial Line.
The Current Configuration table shows the current settings for each CP.
CP
Pin #
Configured as
Value
Groups
Active in group
CP1
Pin 14
Input
0
1
test1
CP2
Pin 16
Input
1
1
test2
CP3
Pin 18
Input
0
0
<available>
CP4
Pin 20
Input
1
0
<available>
CP5
Pin 32
Input
0
0
<available>
CP6
Pin 27
Input
0
0
<available>
CP7
Pin 44
Input
0
0
<available>
CP8
Pin 38
Input
0
0
<available>
CP9
Pin 42
Input
0
0
<available>
CPM – CPs Configuration
Description
CP
Indicates the configurable pin number.
Pin #
Indicates the hardware pin number associated with the CP.
Configured As
Shows the CP configuration. A CP configured as Input is set to read
input. A CP configured as Output drives data out of the PremierWave
EN.
Value
Indicates the current status of the CP:
 1 = asserted.
 0 = de-asserted.

I = the CP is inverted (active low).
Groups
Indicates the number of groups in which the CP is a member.
Active In Group
A CP can be a member of several groups. However, it may only be
active in one group. This field shows the group in which the CP is
active.
To display the CP status of a specific pin. Type show cp<number>.
The CP Status table shows the information about the cp.
Name : CP1
State : Enabled
Value : 0 (0x00000000)
-----------------