User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
5: Line and Tunnel Settings
PremierWave EN User Guide 36
Packing Mode
With Packing, data from the serial Line is not sent over the network immediately. Instead,
data is queued and sent in segments, when either the timeout or byte threshold is reached.
Packing applies to both Accept and Connect Modes.
Tunnel Packing Settings
Description
Threshold
Sets the threshold (byte count). If the received serial data reaches this
threshold, then the data will be sent on the network. Valid range is 100
to 2048 bytes. Default is 2048.
Timeout
Sets the timeout value, in milliseconds, after the first character is
received on the serial Line, before data is sent on the network. Valid
range is 1 to 30000 milliseconds. Default is 1000.
Table 5-7 Using the CLI to Configure Tunnel Packing Mode Settings
To enter Tunnel 1 Packing level
enable->tunnel 1->packing
Table 5-8 Using XML to Configure Tunnel Packing Mode Settings
For Tunnel 1 Packing Mode
configgroup name = "tunnel packing" instance = "1"