User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
5: Line and Tunnel Settings
PremierWave EN User Guide 34
Tunnel Accept Mode
Settings
Description
CP – Group
Configures the name of the CP Group to set upon making or breaking
an Accept mode connection. By default, there is no CP Group set.
Note: See Chapter 6: Configurable Pin Manager
for information on
how to configure the CP groups and pins.
CP – Connection Value
Sets the value to output to the CP Group upon Accept mode
connection. Default is 0.
CP – Disconnection Value
Sets the value to output to the CP Group upon Accept mode
disconnection. Default is 0.
Table 5-3 Using the CLI to Configure Tunnel Accept Mode Settings
To enter Tunnel 1 Accept Mode
level
enable->tunnel 1->accept
Table 5-4 Using XML to Configure Tunnel Accept Mode Settings
For Tunnel 1 Accept Mode
configgroup name = "tunnel accept" instance = "1"