User Manual

Table Of Contents

5: Line and Tunnel Settings

PremierWave EN User Guide 32

Line Settings

The Line Settings allow configuration of the serial Lines (ports).

Some settings may be specific to only certain Lines. Such settings are noted below.

Line Settings

Description

Name

Enter a name or short description for the line, if desired. By default,

there is no name specified. A name that contains whitespace must

be quoted.

Interface

Sets the interface type for the Line. The default is RS232 for Lines 1

and 2, and USB-CDC-ACM for Line 3.

Choices are:

 RS232 (Lines 1 and 2 only)

 RS485 Full-Duplex (Lines 1 and 2 only)

 RS485 Half-Duplex (Lines 1 and 2 only)



USB-CDC-ACM (Line 3 only) = CDC-ACM over USB

Termination

Sets the Line Termination to Enable or Disable. The default is

Disable.

Note: This setting is only relevant for Lines 1 and 2 with Interface

type RS485 Half-Duplex.

State

Sets the operational state of the Line to either Enable or Disable.

The default is Enable.

Protocol

Sets the operational protocol for the Line. The default is Tunnel.

Choices are:

 None



Tunnel = Serial-Network tunneling protocol.

Baud Rate Sets the Baud Rate (speed) of the Line. The default is 9600.

Any speed between 300 and 921600 may be selected, but the

following standard rates are recommended:

300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200,

230400, 460800, 921600.