User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
4: Network Settings
PremierWave EN User Guide 30
WLAN Profile WPA & WPA2
Settings
Description
Encryption
Select one or more encryption types, listed from strongest to least
strong. At least one selection will have to match the Access Points
intended to connect with.
CCMP = Uses AES as basis and is the strongest encryption
option.
TKIP = Uses WEP as the basis, but adds extra checks and
variations for added protection.
WEP = Based on RC4.
Note: In case the encryption settings on the Access Point(s) can
still be chosen, the capabilities of the Access Point(s) and the other
clients that need to use the network need to be taken into account.
RSA Certificate Name
Name of client certificate (required for EAP-TLS.) For more
information about SSL certificates see SSL Settings on page 41.
Table 4-20 Using the CLI to Configure WLAN Profile WPA
and WPA2/IEEE802.11i Settings
Command level
enable>configure>wlan profiles>edit (profile
name)>security>wpax
Table 4-21 Using XML to Configure WLAN Profile WPA
and WPA2/IEEE802.11i Settings
Configuration group name
wlan profile:(profile name)