User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
4: Network Settings
PremierWave EN User Guide 28
Table 4-18 Using the CLI to Configure WLAN Profile WEP Settings
Command level
enable>configure>wlan profiles>edit (profile
name)>security>wep
Table 4-19 Using XML to Configure WLAN Profile WEP Settings
Configuration group name
wlan profile:(profile name)
WLAN Profile WPA and WPA2/IEEE802.11i Settings
WPA and WPA2/IEEE802.11i security suites are available for Infrastructure mode only.
WPA is a security standard specified by the WiFi Alliance and is a close derivative of an early
draft of the IEEE802.11i specification. WEP was becoming vulnerable and finalizing the
IEEE802.11i standard was still far away. WPA2 is WiFi’s subset of the broad IEEE802.11i
standard to enforce better interoperability. The PremierWave EN is compliant with both
WPA2 and IEEE802.11i.
WLAN Profile WPA & WPA2
Settings
Description
Authentication
Selects the authentication method to be used.
PSK = Pre-Shared Key. The same key needs to be configured
on both sides of the connection. (On the PremierWave EN and
on the Access Point.)
IEEE 802.1X = This authentication method communicates with a
RADIUS authentication server that is part of the network. The
RADIUS server will match the credentials sent by the
PremierWave EN with an internal database.
Key
64 hexadecimal digits (32 bytes.)