User Manual

4: Network Settings
PremierWave EN User Guide 25
WLAN Profile Basic Settings
WLAN Profile Basic Settings
Description
Network Name
The name of the wireless network (SSID.)
Note: The PremierWave EN performs only passive scans on
the DFS channels (52–140.) In order for the PremierWave
EN to connect with an access point on one of these channels,
the access point must be configured to broadcast the SSID in
its beacons.
Topology
Specifies Infrastructure (ESS) or Adhoc (IBSS) mode.
 Infrastructure: mode that communicates with access
points.

Adhoc: mode that communicates with other clients.
Channel
Specifies the channel for an Adhoc network.
Note: This setting only applies to the creation of an Adhoc
network.
Table 4-12 Using the CLI to Configure WLAN Profile Basic Settings
Command level
enable>configure>wlan profiles>edit (profile name)
or
enable>configure>wlan profiles>edit (profile #)
Table 4-13 Using XML to Configure WLAN Profile Basic Settings
Configuration group name
wlan profile:(profile name)
WLAN Profile Advanced Settings
WLAN Profile Advanced Settings
Description
TX Data Rate Maximum
Specifies the rate for data transmission.
Note: This setting only applies if ‘TX Data Rate’ is set to
‘Fixed’.
TX Data Rate
PremireWave lets you control the transmission data rate or
controls it automatically.
 Fixed = keeps the transmission rate at the configured
value.
 Auto-reduction = allows the PremierWave EN to reduce
the data rate automatically, depending on link quality.
TX Power Maximum
Maximum transmission output power in dBm.