User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
4: Network Settings
PremierWave EN User Guide 24
WLAN Profiles
A WLAN profile defines all of the settings necessary to establish a wireless connection with
either an access point (in infrastructure mode) or another wireless client (in Adhoc mode.) A
maximum of six profiles can exist on the PremierWave EN at a time. Of these, up to four can
be configured as active (see Profile Choices under WLAN Settings on page 22).
WLAN Profile Management Commands
These commands create, edit and remove WLAN profiles on the PremierWave EN.
WLAN Profile Management
Commands
Description
Show
Display the currently configured WLAN profiles.
Create
Creates a new WLAN profile with default settings.
Edit
Selects a WLAN profile for editing. Editing begins at the ‘Basic’ level
settings for the specified profile.
Delete
Permanently deletes a WLAN profile from the PremierWave EN.
Apply wlan
Immediately applies all changes made to the WLAN configuration
without saving them in persistent storage.
Note: This command is available at all levels within the WLAN
profile.
Write
Immediately applies all changes made to the WLAN configuration
and saves them to persistent storage.
Note: This command is available at all levels within the WLAN
profile.
Table 4-10 Using the CLI to Access the WLAN Profile Management Commands
Command level
enable>configure>wlan profiles
Table 4-11 Using XML to Access the WLAN Profile Management Commands
Configuration group name
wlan profile:(profile name)