User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
4: Network Settings
PremierWave EN User Guide 23
WLAN Link Scan Results Field
Description
Flags
Indicates the security suite in use by the device as well as
whether it is operating in Adhoc (IBSS) mode.
SSID
The Service Set Identifier (network name) of the device.
The results of the status command are presented in the following format:
WLAN Link Status Results Field
Description
Type
Indicates this is a WLAN link
BSSID
A unique identifier for the Basic Service Set corresponding to
the MAC address of the Access Point in infrastructure mode,
or a generated value in Adhoc mode.
SSID
The Service Set Identifier of the connected network.
Topology
The type of wireless network in use for the current association
(Adhoc or Infrastructure).
Active WLAN Profile
Indicates which WLAN profile created the current connection
to the wireless network.
Pairwise Cipher
The standard used to encrypt a particular type of data in the
current wireless association.
Group Cipher
The standard used to encrypt a particular type of data in the
current wireless association.
Security Suite
Indicates the security suite used for the current association.
Channel
The channel used for the current association.
IP Address
The IP address assigned to the PremierWave EN
RSSI
A measure of the power level of the received radio signal in
dBm.
Table 4-9 Using the CLI to Access WLAN Link Information
Command level
enable>configure>if 2>link