User Manual

4: Network Settings
PremierWave EN User Guide 22
Network 2 WLAN (wlan0)
Link Settings
Description
Debugging Level
The Debugging Level sets the verbosity level for printing WLAN Link
messages to the TLOG. (Default is Info)
Available levels, from most to least verbose:
 Dump
 Debug
 Info
 Warning

Error
Table 4-7 Using the CLI to Access Network Link Settings
Command level - wlan0
enable->config->if 2->link
Command level - wlan0
enable->config->if 2->link->choice 1|2|3|4
Table 4-8 Using XML to Access Network Link Settings
Configuration group - wlan0
configgroup name = "wlan" instance = "wlan0"
WLAN Settings
WLAN Link Information Commands
These commands display information about the current state wireless network.
WLAN Link Information
Commands
Description
Scan “<network SSID>”
Performs a scan for devices within range of the PremierWave EN.
Including the optional network SSID limits the scan to devices
configured with the specified network SSID. Omitting the network SSID
performs a scan for all devices in range.
Note: When omitting the network SSID it is still necessary to include the
opening and closing quotation marks (scan “”).
Status
Displays status information about the WLAN link.
The results of the scan command are presented in the following format:
WLAN Link Scan Results Field
Description
BSSID
Basic Service Set Identifier.
Frequency
The frequency on which the device is operating.
Signal Level
The Received Signal Strength Indication (RSSI) of the device
measured in dBm.