User Manual

4: Network Settings
PremierWave EN User Guide 20
Network Interface
Configuration Settings
Description
Hostname
Enter the hostname for the interface. It must begin with a letter or number,
continue with a sequence of letters, numbers, or hyphens, and end with a
letter or number.
Note: This setting will take effect immediately, but will not register the
hostname with a DNS server until the next reboot.
Domain
Enter the domain name suffix for the interface.
Note: This setting will be used when either Static IP or Auto IP is active,
or if DHCP/BOOTP is active and no Domain Suffix was acquired from the
server
.
DHCP Client ID
Enter the ID if the DHCP server requires a DHCP Client ID option. The
DHCP server’s lease table shows IP addresses and MAC addresses for
devices. The lease table shows the Client ID, in hexadecimal notation,
instead of the PremierWave EN MAC address.
Primary DNS
Enter the IP address of the primary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active,
or if DHCP/BOOTP is active and no DNS server was acquired from the
server.
Secondary DNS
Enter the IP address of the secondary Domain Name Server.
Note: This setting will be used when either Static IP or Auto IP is active,
or if DHCP/BOOTP is active and no DNS server was acquired from the
server.
Table 4-1 Using the CLI to Access Network Interface Settings
Command Level - eth0
enable->config->if 1
Command Level - wlan0
enable->config->if 2
Table 4-2 Using XML to Access Network Interface Settings
Configuration group - eth0
configgroup name = "interface" instance = "eth0"
Configuration group - wlan0
configgroup name = "interface" instance = "wlan0"