User Manual
Table Of Contents
- PremierWave EN User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Using DeviceInstaller
- 4: Network Settings
- 5: Line and Tunnel Settings
- 6: Configurable Pin Manager
- 7: Services Settings
- 8: Security Settings
- 9: Maintenance and Diagnostics Settings
- 10: Advanced Settings
- 11: Tunneling
- 12: Security in Detail
- 13: Updating Firmware
- A: Technical Support
- B: Binary to Hexadecimal Conversions
- C: Compliance
- D: Warranty
- E: USB-CDC-ACM Device Driver File for Windows Hosts
- Index
PremierWave EN User Guide 19
4: Network Settings
The Network Settings show the status of the Ethernet or WLAN interface/link and let you
configure the settings on the device. Interface settings are related to the configuration of the
IP and related protocols. Link settings are related to the physical link connection, which
carries the IP traffic.
The PremierWave EN contains two network interfaces, only one of which may be active at a
time. The Ethernet interface is also called interface 1 or eth0, and the WLAN interface is
called interface 2 or wlan0.
Note: Some settings require a reboot to take effect. These settings are noted below.
Network Interface Settings
This table shows the settings for the network interface configuration. These settings apply to
both the Ethernet and WLAN interfaces, but are configured independently for each interface.
Network Interface
Configuration Settings
Description
State
Enables or disables the interface.
BOOTP
Select Enable or Disable. At boot up, after the physical link is up, the
PremierWave EN will attempt to obtain IP settings from a BOOTP server.
Notes: Overrides the configured IP address/mask, gateway, hostname,
and domain.
When DHCP is Enable, the system automatically uses DHCP, regardless
of whether BOOTP is Enable.
Changing this value requires you to reboot the device.
DHCP
Select Enable or Disable. At boot up, after the physical link is up, the
PremierWave EN will attempt to obtain IP settings from a DHCP server
and will periodically renew these settings with the server.
Notes: Overrides BOOTP, the configured IP address/mask, gateway,
hostname, and domain.
Changing this value requires you to reboot the device.
IP Address
Enter the static IP address to use for the interface. You may enter it alone
or in CIDR format.
Notes: This setting will be used if Static IP is active (both DHCP and
BOOTP are Disable).
Changing this value requires you to reboot the device.
When DHCP or BOOTP is enabled, the PremierWave EN tries to obtain
an IP address from a DHCP or BOOTP server. If it cannot, the
PremierWave EN generates and uses an Auto IP address in the range of
169.254.xxx.xxx, with a network mask of 255.255.0.0.
Default Gateway
Enter the IP address of the router for this network.
Note: This setting will be used if Static IP is active (both DHCP and
BOOTP are
Disable
).