User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
5: Allowable Antennas to use with the Radio Module
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
9
5 Allowable Antennas to use with the Radio
Module
The module is certified for use with certain antennas as described in this section.
Allowed Antenna Types:
1. Dipole antenna
Table 1 Allowed Maximum Gain (dBi) Dipole, Including Cable Loss
2.4~2.5GHz
3.32
4.9~5.8GHz
6.11
The required antenna impedance is 50 ohms.
Use of other antenna types or the same type of antenna but with higher gain than listed above is not
allowed without additional testing and appropriate FCC or IC approval.