User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
3
Revision History
Date
Rev.
Comments
April 2021
0.0
Initial Draft
May 2021
0.1
Changed minimum distance of usage from antenna to user
to 21 cm for FCC and 24 cm for ISED. Pages 10,16,17,18
&19.
For the latest revision of this product document, please go to: http://tech.intrinsyc.com.
Note: The Lantronix Open-Q 845 uSOM radio module (the “Module”) is certified for
compliance for use in the USA and Canada only. For use in other countries, certificates of
compliance must be obtained for that country or region before the module can be sold,
operated or incorporated into products. In addition, any deviation from the settings,
methods, conditions and restrictions for integration of the Module into a host system, as
defined in this document, could be a violation of applicable national law and may be
punishable as such, and in such event, the products into which the Module is incorporated
may not be lawfully distributed or sold in such countries. Lantronix assumes no responsibility
for any such liability or loss related to installation or operation of the Module.