User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
11: Required Regulatory Wording for End User Manual /
Installation Manual
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
19
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed and
operated with minimum distance of 24 cm between the antenna and users. The final end product must be
labeled in a visible area with the following: “Contains IC: 3867A-OQ845US”.
Plaque signalétique du produit final
Ce module émetteur est autorisé uniquement pour une utilisation dans un appareil où l'antenne peut être
installée et utilisée avec une distance minimale de 24 cm entre l'antenne et les utilisateurs. Le produit
final doit être étiqueté dans une zone visible avec ce qui suit: "Contient IC: 3867A-OQ845US".
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as shown in this manual.
Manuel d'information à l'utilisateur final
L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la
façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre
ce module.
Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et
avertissements comme indiqué dans ce manuel.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
(ii) for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the bands
5250-5350 MHz and 5470-5725 MHz shall be such that the equipment still complies with the e.i.r.p. limit;
(iii) for devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band
5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits as appropriate;
(iv) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to
remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly
indicated.