User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
11: Required Regulatory Wording for End User Manual /
Installation Manual
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
16
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 21 cm between the radiator
& your body.
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01
guidance, the following conditions must be strictly followed when using this certified module:
KDB 996369 D03 OEM Manual v01 rule sections:
2.2 List of applicable FCC rules
This module has been tested for compliance to FCC Part 15.247 and 15.407.
2.3 Summarize the specific operational use conditions
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions
such as co-location with other transmitter(s) or being used in a portable condition will need a separate
reassessment through a class II permissive change application or new certification.
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 21 cm
between the radiator & your body. If the module is installed in a portable host, a separate SAR
evaluation is required to confirm compliance with relevant FCC portable RF exposure rules.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type
with equal or lower gain may also be used with this module. The antenna must be installed such
that 21 cm can be maintained between the antenna and users.
Antenna Type:
Flexible Dipole Antenna
Antenna connector:
U.FL
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
R68OQ845US”. The grantee's FCC ID can be used only when all FCC compliance requirements are
met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or
simultaneous transmission with other transmitter(s) or portable use will require a separate class II
permissive change re-evaluation or new certification.