User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
10: Required Labeling on the Module
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
14
10 Required Labeling on the Module
10.1 FCC and Industry Canada Labeling on the Module
The OEM integrator must ensure that the FCC ID and IC number is affixed on the Module or in a
User/Installation Manual along with other country certification numbers and logos as described herein.
Note: the original Module manufacturer may affix regulatory labeling at time of Module manufacturing.
However, the OEM integrator must ensure that Module labeling is complete, correct, and applicable for all
the countries to which the host system is to be imported, marketed, or sold.