User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
9: Required Labeling on the Outside of the Host
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
13
9 Required Labeling on the Outside of the Host
9.1 FCC Labeling Requirements on the Outside of the Host
The FCC requires a label on the outside of the host system visible to the end user. Example wording is:
Contains:
FCC ID: R68OQ845US
IC: 3867A-OQ845US
The FCC requires a logo signifying emission compliance on the outside of the host system. The OEM
integrator is responsible to perform FCC Part 15 Class B digital emissions testing on the end system with
the radio Module installed. The FCC logo below should not be affixed unless the OEM integrator has
obtained the necessary Part 15 approval, e.g., self-declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of certification issued
by a TCB, the FCC ID number shown on the grant should be used on the label instead of the FCC logo
below.
Also see https://www.fcc.gov/logos.
A certified modular has the option to use a permanently affixed label, or an electronic label (Refer to FCC
KDB 784748 D02 e labeling for e-labelling guidance). All modules without an integrated display on the
module must be labelled with a module’s FCC ID - Section 2.926.
9.2 Industry Canada Labeling Requirements on the Outside of the
Host
End Product Labeling
The final end product must be labeled in a visible area with the following for the
Open-Q 845 uSOM: Contains IC: 3867A-OQ845US.
Plaque signalétique du produit final
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante:
Open-Q 845 uSOM: Contient des IC: 3867A-OQ845US.