User Guide
Table Of Contents
- Contacts
- Revision History
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for End User Manual / Installation Manual
- 12 OEM Integrator Checklist
8: Module May Not Be Installed by End Users
Open-Q 845 uSOM Module Certification OEM Integrator
Guide
12
8 Module May Not Be Installed by End Users
FCC and IC rules require this Module to be installed in host systems at the factory by the OEM integrator.
Thus, end users of the system may not install the Module. Therefore, the host product user instructions
must not advise the end user on how to access or remove the Module. Additional FCC authorization/filing
is needed to allow end user installation of the radio modules.
If modules are provided to the end users for installation in the host, a two-way authentication protocol is
required to limit the module to operate only with the authorized host system.