User's Manual

5: Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide 61
Default Settings
Select 7 Default Settings from the Change Setup menu to reset the unit’s Channel 1
configuration, Channel 2 configuration, Email settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP
address, netmask, wireless enable, infrastructure or ad hoc setting, and wireless
security settings remain unchanged. The configurable pins’ settings also remain
unchanged. The specific settings this option changes are listed below.
Note: To reset to factory defaults, use the “Reset to Defaults” Configurable
Pin. For more information on Configurable Pins, see Configurable Pins page
63.
Channel 1 Configuration
Baudrate
9600
I/F Mode 4C (1 stop bit, no parity, 8 bit, RS-232C, no flow
control)
Port No
10001
Connect Mode C0 (always accept incoming connection; no active
connection startup)
Hostlist Retry Counter
3
Hostlist Retry Timeout
250 (msec)
Send Character
0x0D (CR)
All other parameters
0
WLAN Settings
Topology
1 (AdHoc)
Network Name
LTRX_IBSS
Channel
11
Security
0 (none)
TX Data Rate
0 (fixed)
TX Data Rate
11 Mbps
Enable Power Management
N (No)
Expert Settings
TCP Keepalive
45 (seconds)
ARP Cache Timeout
600 (seconds)
CPU Performance
Regular
Disable Monitor Mode
(N) No