User's Manual

5: Configuration via Serial Mode or Telnet Port
MatchPort b/g™ User Guide 48
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the MatchPort’s ability to send the escape sequence. The default is
Y (Yes) (send the escape sequence).
Show IP addr after 'RiNG'
Disable or enable the MatchPort's ability to show the IP address after RING in
Modem Mode. The default is Y (Yes), to show the IP address.
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increment the source port. The MatchPort increments the port number
used with each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : ( 0) ( 0) ( 0) ( 0)_
Note: This option is not displayed when Hostlist is enabled from the
ConnectMode prompt (see page 42 for more information).
Remote Port
Set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is
attempted.
Remote Port ( 0) ? _
To connect an ASCII terminal to a host using the unit for login purposes, use the
remote port number 23 (Internet standard port number for Telnet services).
Note: This option does not display when Hostlist is enabled from the
ConnectMode prompt (see page 42 for more information).
DisConnMode
Disconnect Mode (DisConnMode) determines the conditions under which the unit will
cause a network connection to terminate. The current value displays in parentheses.
DisConnMode ( 0) ? _
Note: All bit positions in the table that are blank represent "don't care" bits for
that particular option, which can be set to either a 0 or a 1 value.
The following table displays the available input options: